Small Circle Cutting Guide

Small circle cutting guide is a simple device which clamps over the 3 cutting torch tubes.The point is adjustable for height so may be used with both ANM (76mm) and ANME (88mm) type cutting nozzles.First the plate in which the hole is to be cut is pierced and the cut run out to the circumference, the point of the small circle cutting guide is placed in a "centre pop" mark in the plate surface. From the pierce cut the circle is then cut in the plate pivoting the torch about the centre point.The upper knob is the clamping screw for opening the clamp and tightening the clamp to the cutting torch tubes.The lower screw is to fix the height of the nozzle above the plate surface. The pre-heat cones should be approximately 1,6mm above the plate surface, the torch tubes should be parallel to the plate surface.With the small circle cutting guide fitted to an Excalibur NM250 blowpipe cicles from 70mm diameter to 520mm diameter may be cut.

For more information on Small Circle Cutting Guide talk to Noz-Alls Ltd