Cosy-floor Kit 1 single room DIY warm underfloor heating kit

A single room DIY warm underfloor heating kit for small extensions, Bathrooms, Kitchens etc. Works in conjunction with existing pump so doesn’t require any electric wiring. The extension to have underfloor heating should represent a small part of the overall Radiator system operating at the normal temperature of approximately 80c Flow / 70c Return. The floor heating tubing should be installed on top of good quality floor insulation and covered by a sand and cement screed normally 4 Sand/1Cement. Floor finish should be as Ceramic Tiles, Slate etc. This underfloor heating Pack includes:- *50 metres 16mm OD High temperature Pert- Al – Pert Pipe which is tested and approved for temperatures and pressures well above those required for floor heating. The pipe has a 100% oxygen barrier. Click for tube specification * One danfoss FHV-R Regulating Valve and Return Water Temperature Limiter. Click for specification * 100 push in pipe clips * Fittings to join 16mm pipe to regulating valve and to 15mm copper pipe. *12 metres 8mm x 130mm edge insulation. * Installation Manual The tubing must be cut with a pipe cutter and re rounded using a plastic reamer. So as not to financially penalize regular users we don’t include these items in this Under floor heating Kit. If you don’t already have these items they can be purchased from our Tool Section An underfloor heating system with this type of control should have a maximum floor heating Tube spacing of 150mm c to c, at this spacing this kit will cover an area of 7.5 square metres. For Higher heat loss areas you can reduce the centres to as low as 100 mm c to c at this spacing the tubing would cover an area of 5 square metres

For more information on Cosy-floor Kit 1 single room DIY warm underfloor heating kit talk to Total Floor Heating Ltd