Sign In
Central Processing Unit (CPU)
Product Code: 00-00620-981
The PMC CPU is the main component of Intellitec's
Programmable Multiplex Control family. It controls remote
I/O modules through Intellitec's multiplex communications
system (Pat. No. 4,907,222 and 6,011,997). This multiplex
system allows the CPU, I/O Modules and switch panels to be
wired together with two wires.
The CPU has three, 3-pin, Amp Mate-N-Lok connectors
which are used to communicate to the Input/Output
modules. One pin is the multiplex signal, another is
multiplex Ground, and the third is fused power to operate
remote switch panel backlighting.
Multiple modules can be wired to a single connector. All
input, or switch information is gathered through the remote
modules and directly communicated to the CPU. The CPU
then interprets the inputs, determines the states of all
outputs and communicates that information to the remote
modules via thePMCcommunications link.
The CPU can communicate with up to 16 modules. Each module can have a combination of up to 10 inputs or outputs,
with a singleCPUcontrolling up to 160 inputs/outputs. If your system requires more than 160 I/O points,CPU00-00800-
021 can be used.
The CPU also has 10 timers built-in, which are setup by the Windows software. These timers can function as on/delay,
off/delay, and interval timers. PMC can replace flasher modules, mirror heat timers, wiper delays, or any other timer
function.
The CPU RS-232C communications ports is used to setup, or program the vehicle specific requirements. The port can
also be used to perform system diagnostics; , 99% of the diagnostics can be easily performed on the multiplex
communication wires with the use of a commonly available Volt Meter.
The PMC system communicates continually at a relatively slow rate of 4 kHz. Each input/output is updated every .040
seconds. The multiplex signal, which communicates to the output modules, switches all the way from ground to the
battery voltage. This slow communications rate and large signal voltage change makes the PMC system extremely
resistant to interference from EMI and RFI. Because of the low communications frequency and large signal change,
communication can take place without fear of interference over any economical wire and eliminates the need for special
cables and connectors. Four high speed channels are available to control elements requiring a higher speed.
The CPU includes a sleep mode. The sleep mode reduces the overall system operating current, allowing the system to
be constantly live with insignificant drain on the vehicle battery.
Through the use of Intellitec's PMC Windows based software program and the connection of a PC to the RS-232C port,
the user can easily set up the relationships between the switch inputs, timers and outputs. If desired, Intellitec can ship
CPUmodules to theOEMwith their program already loaded.
If your customer needs a modification, a CPU can be programmed at your desk and shipped overnight. The plugs are
designed so that theCPUcan only be plugged in one way. TheCPUmay also be reprogrammed over and over again. In
thePMCsystem, the only module that needs programming is the CPU.
All the harnesses are connected withAMP Mate-N-Lok connectors to reduce installation time and errors. Combine the
Programmable Multiplex Control Central Processing Unit with the Intellitec standard, semi-custom or custom modules,
and you can create the exact system configuration that you want, from basic to all encompassing. The approximate
module dimensions are 6.375" X 6.250" X 1.875" (16.2mm X 15.9mm X 4.8mm).
however
The module should be installed in a
protected environment inside of the vehicle.
For more information on Central Processing Unit (CPU) talk to Intellitec MV Ltd
Enquire Now
List your company on FindTheNeedle.