Wireless Radiation Monitoring - C2371A TELETERM W3 ?ISA100Wireless? Interface

Overview The Teleterm W3 ISA100Wireless Interface Node for Wireless Radiation Monitoring provides a convenient means to network all your radiation monitors over an ISA100 wireless network. Attach a Teleterm W3 to each monitor and transmit monitor readings and alarms wirelessly to your control centre to eliminate costly installation network cabling and allows for mobile monitoring. Supports a wide range of Radiation Monitors The Teleterm W3 has a standard RS232/RS485 serial communications link to connect to a radiation monitor, and is supplied with built in support for a wide range of monitors including models from Canberra, Lab-Impex Systems / Ultra Electronics. (See the list of supported radiation monitors in the Specifications). If your monitor is not listed, consult with your Omniflex representative for availability of our Wireless Radiation Monitoring. ISA100.11a wireless network ISA100Wireless is an international standard (IEC 62734), and is an open wireless network that is scalable, reliable and secure. ISA100 comes with ?IPv6? addressability which makes it the only industrial network protocol compatible with the ?Internet of Things?. ISA100 Wireless Radiation Monitoring operates over the 2.4GHz ISM (non-domestic) band using the widely supported IEEE802.15.4 radio standard. This means no special licencing is required to operate an ISA100 wireless network. Being an industry standard network, the Teleterm W3 can be used with any ISA100 compatible Wireless Access Point (WAP) to connect your monitors to your central monitoring and control system. The ISA100 wireless standard integrates high level cyber security features to ensure data integrity, confidentiality and authenticity. Simple configuration The Teleterm W3 comes preloaded with support for a range of radiation monitors allowing a minimum of configuration to connect a radiation monitor to the wireless network. Fully configurable using Omniset. Two steps for configuration - Step 1: Configure the ISA100 network parameters. Step 2: Set the radiation monitor type and respective parameters. ISA100 network topology There are two network topologies supported by ISA100. Star network topology, where every monitor is in range of a Wireless Access Point; and mesh topology where monitors out of range of the network access point pass their data on to other monitors to relay that data back to the Wireless Access Point. Supports ?DuoCast? which allows network redundancy. Consult your ISA100 network installer for the most appropriate configuration for your network. Often a simple site survey is required to determine the possible locations for ISA100 network nodes Update rate The update rate of data on the ISA100 network can be adjusted from 8 to 3600 seconds. A faster update rate reduces the number of monitors that may be connected to the network. The Teleterm W3 is shipped with a default update rate of 8 seconds, which allows up 500 monitors to be connected to the ISA100 wireless network.

For more information on Wireless Radiation Monitoring - C2371A TELETERM W3 ?ISA100Wireless? Interface talk to Omniflex UK Limited